The HP printer carriage jam issue is a quite common and irritating one. Once this error occurs, then an error message saying ‘Carriage Jam’ continuously pops up on the screen.
As a result, your HP printer stops printing. Most of the time due to the paper jam, you can face this problem.
Although this is a difficult problem to get rid of, you can still troubleshoot it with some proven techniques.
For that, you have to follow a proper strategy. Now, go through the remaining part in order to eliminate this issue permanently from your HP printer.
Troubleshoot and Fix HP Printer Carriage Jam Error with Premium Solutions:
Keep an eye on the effective solutions listed below to fix this issue instantly.
Solution 1- Perform a Keen Visual Inspection
We suggest you removing all the unnecessary paper by lifting the left and right tab.
Apart from that, we also suggest you to carefully remove the jammed paper from any rollers and after that, replace the rear access door.
Solution 2- Looking for the Stuck Paper
In case, the above two solutions do not work for you, then we suggest you check for any stuck sheet of paper.
If found, then replace it immediately and do not worry. Just take a look at the next solution.
Solution 3- Reinstall the Ink Cartridges
Improper installation of the ink cartridges might also lead to the HP printer carriage jam issue.
So, you have to make sure that the ink cartridges are correctly installed and for that, at first, remove the ink cartridges and thereafter, reinstall them again.
Here are the steps that you need to follow to apply this solution on your device.
In the beginning, turn on your HP printer. Next, you have to open the ink cartridge access door.
Wait, until the carriage is idle and silent before you start.
Then, you need to release the ink cartridges and to do so, you have to lift the lid on the ink cartridges slot.
Next, draw the ink cartridge for removing it from the slot.
Now, if required, then remove the protractive type from the contracts. Thereafter, you have to hold an ink cartridge.
Next, what you need to do is to close the lid of the ink cartridges to protect it from other damages.
You might need to repeat those steps in order to remove and reset the other ink cartridges. Now, you need to close all the ink cartridge access door.
Finally, reboot your HP laptop and if you are still dealing with this HP printer issue, then here is another quick solution at your rescue.
Solution 4- Directly Plug the HP printer into a Wall Outlet
This is another solution that you can try to fix the issue. To apply this solution on your device, go through the steps provided below.
- At first, disconnect the Power cord from the printer.
- After that, you have to remove the Power cable from the Power outlet.
- Next, plug the Power cable directly within an electrical outlet.
- Next, you need to connect the Power cord to the HP printer.
- After that, you have to turn on your HP printer.
- Thereafter, try to print anything.
If you can print, then your job is over, otherwise, have a look at the next solution.
Solution 5- Reset the Printer
If none of the above solutions work for you, then resetting the printer can clear the jam. Take a look below.
- In the beginning, turn the HP printer on. Thereafter, disconnect the Power cable from the rear of the HP printer. After that, unplug the Power cable from the wall outlet.
- Next, at least wait for 60 sec. Thereafter, plug the Power cable back again within the wall outlet.
- Thereafter, turn on the HP printer, in case it is not automatically turned on.
In case, the error is still there, then proceed to the next solution.
We wrap the short discussion on how to troubleshoot this error here.
We believe with the help of the above-mentioned solutions, you can resolve the clear cartridge jam HP printer on your own.
However, if you think you don’t have that much knowledge on how to apply those solutions, then do not waste your valuable time and rely upon an expert to get the permanent solution on this.